Kidde I9060 Bedienungsanleitung PDF herunterladen (Seite 10)

4. Operation and Testing

OPERATION: The smoke alarm is operating once a fresh battery is

installed and testing is complete. When products of combustion are

sensed, the unit sounds a loud 85db pulsating alarm until the air is

cleared.

HUSH CONTROL: The “HUSH” feature has the capability of temporarily

desensitizing the alarm circuit for approximately 8 minutes. This feature

is to be used only when a known alarm condition, such as smoke from

cooking, activates the alarm. Models i9060, i9060RV and i9080 are

desensitized by pushing the “HUSH” button on the smoke alarm cover.

Models i9030, i9040, i9040RV and i9050 are desensitized by pushing

the TEST/HUSH button on the cover. If the smoke is not too dense, the

alarm will silence immediately and the Red LED will flash once every 10

seconds for approximately 8 minutes. This indicates that the alarm is in a

temporarily desensitized condition. The smoke alarm will automatically

reset after approximately 8 minutes and sound the alarm if particles of

combustion are still present. The “HUSH” feature can be used repeated-

ly until the air has been cleared of the condition causing the alarm.

NOTE: DENSE SMOKE WILL OVERRIDE THE HUSH CONTROL FEA-

TURE AND SOUND A CONTINUOUS ALARM.

CAUTION: BEFORE USING THE ALARM HUSH FEATURE, IDENTIFY

THE SOURCE OF THE SMOKE AND BE CERTAIN A SAFE CONDITION

EXISTS.

FLASHING LED LIGHT: This smoke alarm is equipped with a flashing

red indicator light. The light is located under the test button and will

flash every 40 seconds to indicate that the smoke alarm is receiving

power.

TESTING: Test by pushing the test button on the cover and holding it

down for a minimum of 5 seconds. This will sound the alarm if the elec-

tronic circuitry, horn, and battery are working. If no alarm sounds, the

unit has defective batteries or other failure. DO NOT use an open flame

to test your alarm, you could damage the alarm or ignite combustible

materials and start a structure fire.

TEST THE ALARM WEEKLY TO ENSURE PROPER OPERATION.

Erratic or low sound coming from your alarm may indicate a defective

alarm, and it should be returned for service (see section 12).

NOTE: WEEKLY TESTING IS REQUIRED.

0930-7203-00(820-1493B)_EN:_ 2011.1.5 2:08 PM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Kidde I9060 Bedienungsanleitung Seite 10