Kidde KN-COSM-IB Bedienungsanleitung PDF herunterladen (Seite 18)

Operating Instructions

CAUTION: BEFORE USING THE ALARM HUSH FEATURE,

IDENTIFY THE SOURCE OF THE SMOKE AND BE CERTAIN A

SAFE CONDITION EXISTS.

Reset Feature

If the the Smoke/CO Alarm is sounding a CO alarm, pressing the

test/reset button will silence the alarm.

If the CO condition that caused the alert continues, the alarm will

reactivate within 200 seconds.(see page 21).

Peak Level Memory

If the green LED is blinking once every 15 seconds, the unit has

detected a hazardous CO condition. If the CO sensor has

detected a CO level of 100 PPM or higher since last reset, it will

be recorded by the Peak Level Memory function. To access the

Peak Level Memory press the test/reset button. If a reading of

100 PPM or higher has been recorded, the unit will announce

“Carbon Monoxide Previously Detected.” If you’ve been away

from home this feature allows you to check if there was a CO

reading of 100, or higher, during your absence. Pushing the

test/reset button resets the memory. It’s also reset when the

power is removed.

LED Indicator Operation

Red LED

The red LED will flash as described below under the following

conditions:

--During smoke or CO alarm, with every beep

--During testing (same as alarm)

--Low battery, single flash with chirp

--End of product life, double flash every 30 seconds with chirp

--Unit error mode, single flash with chirp

--Unit error mode, a Fault Code is flashed every 30 seconds (can

be observed and reported to customer service for

troubleshooting).

2544-7201-00(KN-COSM-IBA)_V4a.qxd:_ 2013.7.1 2:44 PM Pag

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Keine Kommentare

Kidde KN-COSM-IB Bedienungsanleitung Seite 18