Kidde SLED177I Gebrauchs- und Pflegehandbuch

Stöbern Sie online oder laden Sie Gebrauchs- und Pflegehandbuch nach Kohlenmonoxid (CO) -Detektoren Kidde SLED177I herunter. Kidde SLED177i Use and Care Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 14
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
ATTENTION! The model SL177 and SL177i strobe lights are designed to notify hearing
impaired individuals of impending danger, they have no detection means and MUST be
used in conjunction with operating Smoke, Heat, or Carbon Monoxide Alarms.
The model SL177i AC wire-in Strobe light can be directly interconnected with Kidde
Safety 3-wire Smoke, Heat and CO alarms. It will produce an intermittent flash pattern
(approximately 4 flashes, followed by approximately 5 seconds off) when triggered by a
Carbon Monoxide alarm and a steady flash when triggered by a smoke or heat alarm.
The model SL177 is a 2-wire device that can be used to add strobe light capabilities to
existing alarm systems produced by other manufacturers. A relay module or suitable
switching device ( not included), which is compatible with the alarm system will be
needed to energize the strobe light. Consult the alarm manufacturer to obtain the prop-
er switching device for your specific alarm model.
Thank you for purchasing this strobe light. It is an important part of your family’s home
safety plan. You can trust KIDDE Safety to provide the highest quality safety products.
We know you expect nothing less when the lives of your family are at stake.
For models: SL 177i and SL 177
P/N 810-1779-EN Rev. B
1100-7210-00
Strobe
Light
For your convenience, write down the following information. If you call
our Consumer Hotline, these are the first questions you will be asked.
Strobe Light Model Number
(located on back of alarm):
Date Code (located on back of device):
Date of Purchase:
Where Purchased:
SL 177 SL 177i
Strobe Light User’s Guide
1100-7210-00(810-1779-EN B):_ 2011.2.17 4:27 PM Page 1
Seitenansicht 0
1 2 3 4 5 6 ... 13 14

Inhaltsverzeichnis

Seite 1 - Strobe Light User’s Guide

ATTENTION! The model SL177 and SL177i strobe lights are designed to notify hearingimpaired individuals of impending danger, they have no detection mea

Seite 2 - 1. SPECIFICATIONS

AFTER CLEANING, REINSTALL YOUR STROBE LIGHT AND TEST YOURSTROBE LIGHT BY ACTIVATING ONE OF THE CONTROLLING ALARMS.8. LIMITATIONS OF ALARM CONTROLLED V

Seite 3

9. GOOD SAFETY HABITSDEVELOP AND PRACTICE A PLAN OF ESCAPE• Install and maintain Fire extinguishers on every level of the home and in thekitchen, base

Seite 4 - 4. LOCATIONS TO AVOID

• Once outside, go to your selected meeting place and make sure everyone isthere.• Call the fire department from your neighbor’s home - not from yours

Seite 5 - 5. INSTALLATION INSTRUCTIONS

11. SERVICE AND WARRANTYIf after reviewing this manual you feel that your Visual Signaling Device is defec-tive in any way, do not tamper with the uni

Seite 6 - FIGURE 2

FIVE YEAR LIMITED WARRANTYKIDDE Safety warrants the original purchaser that the enclosed Visual signaling Devicewill be free of defects in material an

Seite 7

IMPORTANT! READ ALL INSTRUCTIONS BEFORE INSTALLATION AND SAVETHIS MANUAL FOR FUTURE REFERENCE WARNING! THIS VISUAL SIGNALING DEVICE HAS NO DETECTION

Seite 8

Multiple station (24) interconnect unit, interfaces directly with KiddeSafety:Ion Smoke Alarm Models: 1235, 1235CA, 1275, 1275CA, 1276, 1276CA, 1285,

Seite 9 - 7. MAINTENANCE

The following diagram shows that the light intensity gradually decreases as theviewing angle is increased. Use this information to determine the best

Seite 10

5. INSTALLATION INSTRUCTIONSREAD CAREFULLY – WIRING REQUIREMENTS• This smoke alarm should be installed on a U.L. listed or recognized junctionbox. All

Seite 11 - 9. GOOD SAFETY HABITS

5. Figure 1 illustrates interconnection wiring. Improper connection will result indamage to the strobe light or alarms, failure to operate, or a shock

Seite 12 - 10. NFPA REQUIRED PROTECTION

CONNECT 2-WIRE HARNESS.Figure 2 illustrates the proper SL177 wiring. Improper connection will result indamage to the strobe light or alarms, failure t

Seite 13 - 11. SERVICE AND WARRANTY

mount the ring, making sure that the mounting screws are positioned in thesmall ends of the keyholes before tightening the screws (see fig. 3).• Plug

Seite 14 - FIVE YEAR LIMITED WARRANTY

notification equipment interconnected with heat, smoke, or CO alarms in the liv-ing rooms, dining rooms, kitchens, hallways, attics, furnace rooms, cl

Kommentare zu diesen Handbüchern

Keine Kommentare